How to Insert a Battery into a Trimmer

Page 3: Device Maintenance, Attention

Attention! The text in this document was recognized automatically. To view the original page, you can use the mode “Original”.

(A) Protective cap

(B) External cutting unit

(C) External cutting holder

(D) Inner cutting unit

(E) Connecting rod

(F) Power Switch (ON / OFF)

To turn on the device,

Slide the switch up

(H) Battery cover

Rotate the battery covercounterclockwise
line (a) with line (b) and pull the cover to

Yourself to open the compartment. Paste in

One AA battery (R6), observing

Larity. To install the cover on

Place, repeat the above
the procedure in the reverse order.

How to use a trimmer

Slide the power switch up andcarefully insert the tip of the external
chewing block in the nostril or ear
verst. To wind hairs out of them.

Before dismantling, replacing

Or clean the cutting units, make surethat the power switch is set toOFF position (device off).

To remove the holder from the trimmer

Outer cutting unit, turn

Holder so that fishing line (s)
stretched with line (d) and then pull it

Up (see fig. 3).
Disconnect the internal cutting unitfrom the outside. Wipe the blade thin

With a cloth to remove hairs from them,

All DEVICE CAN FULL
STYU WASH IN WATER.
Do NOT USE BOILER FORWASH TRIMMER.

Reinstall the inner cutting unitto the outside. To install the holderexternal cutting unit back totrimmer housing, align marks (c)and (b) and turn the holder clockwisearrow until it clicks into place.

Do not insert the trimmer into the nostril or ears.
The hole is deeper than it allows

Narrow part of the outer cutting unit.

In addition, you cannot do this with effort.Do not attempt to use the device.

In case of deformation or damage one

Or several external cutting blades
block, as in this case you can

You may injure your ear or nose.
This trimmer is designed to exclude

Specifically for removing hair from the nose and

Ears. Use it for its intended purpose only.
Reading.
Trimmer Cutting Blocks Designed
we are made on the basis of exact races
couple. Do not expose them to excessive
load. Strokes, etc.
Before. How to clean the cutting blocks

Make sure the power switchset to OEE. If pol

Trim once a week1 minute, then the life of the cuttingblocks will be approximately 3 years.
Do not try to disassemble yourself,repair or modify the mouth
swarm, as this may lead to

Injury or other unforeseen

The consequences.
Do not wipe the trimmer with solvent.

Gasoline or alcohol. Clean it weave

New slightly moistened in clear water.

Before HOW TO USE

Trimmer CAREFULLY READ
THESE INSTRUCTIONS FOR USE.