STANLYY TRAINED Tractor where lower gear. How to run a single tractor correctly?

Stanley’s Unoa.based 1900 tractor with reduced gear Stanley’s Unoa.based 1900 tractor is produced by a German company. Quality control of products occurs at each stage of assembly of the device. The manufacturer’s guarantee for the Shtenli 1900 Pro SERIS Tractor is 2 years. Photos of the walk.behind tractor is presented below. This device is equipped with a four.stroke gasoline engine […]

Read more

How to remove the gear from an electric screwdriver. Disassembly of the screwdriver

How to remove the gear from the motor of an electric screwdriver An electric screwdriver is an electric hand-held tool for tightening or unscrewing screw-type fasteners. Its direct purpose is to work with screws. Quite often the electric screwdriver is used as a drill (for drilling), which leads to its failure. The fact that this unit has a mechanism for […]

Read more
blank

How to disassemble the gear reducer of a Makita angle grinder. How to remove the anchor from the angle grinder?

How to disassemble the angle grinder yourself In all the time I have been using the power tool, this is the first time I have “burned” it myself. During prolonged use, my Makita 9555HN angle grinder started to smoke very badly. It was caused by haste and inattention at the same time. In the combination of all my actions and […]

Read more
blank

What is the gear ratio of the gearbox of an angle grinder?. Gear lubrication of angle grinder: how to replace than lubricate and when to change

Grinder Repair With Your Own Hands An angle grinder is an angle grinder (angle grinder) that requires careful handling. However, sometimes it fails and can not work properly. For quality repair of the angle grinder with your own hands it is necessary to get acquainted with the design features of the tool. Anchor. this element is located in the electric […]

Read more
blank

How to lubricate the gear reducer of the grass trimmer Champion. Lubrication of the lower and upper gearbox

Repair and lubrication of the grass trimmer gearbox If you use your brushcutter a lot, the gearbox can get hot or make unusual noises, such as grinding, that are unusual for normal operation. This indicates that the mechanism needs to be lubricated. If this is not done in time more serious problems will occur (for example, the gears will quickly […]

Read more
blank

P 08361 Makita Gear Lubricant

Makita gear lubricant 30 grams P-08361 Antalex. offers the opportunity to buy grease for the gearbox 30 grams Makita P-08361 wholesale, retail at the lowest prices. The lubricant is well suited for lubricating the gearboxes of tools that are used in conditions of severe vibration or shock loads, such as for perators or jackhammers. Important properties of this lubricant are […]

Read more
1 2 3