Reviews of popular models of garden equipment ~ lawn mowers, trimmers, brush cutters, mowers ~ CHAIKA.NET Tips and solutions to possible problems during operation
The vibration plate does not trim the earth The likely cause of the breakdown Debugg The ignition switch is switched to the “OKL” position Transfer the switch to the working position The air damper is in the wrong position Translate the damper to the necessary position. Details of the operation, see the operating instructions in the section Preparation for the […]
Read more
Vibratory plates in operation This article takes a closer look at all aspects of operating a vibratory plate, and explores how to. You can break vibratory plate usage down into a few things: a long time in storage, transport, active use. You would logically need to do most of the work if you use your plate extensively, so we’ll divide […]
Read more
Further information Quite often the inertia clutch is used. In it, the levers are connected to the drive shafts and are complemented by cams. These cams are driven by the force of inertia into the grooves placed on the cup-shaped coupling half. This coupling half is in turn connected to the drive shaft. Levers are mounted on a common axis […]
Read more
Renault Megane Oil Filter On Renault Megane 3 with a diesel engine, Renault part number 152085488R is used to replace the oil filter element with the original. The following options are used as analogues: Original oil filter 152085488R 10122. JAPKO; 33572. ASAM; OC978. KNECHT; F 026 407 176. Bosch; W7032. MANN-FILTER. Characteristics of the oil filter for diesel Megane: outer […]
Read more
All about compaction of sand Before the installation of foundation structures or preparatory work under the screed, as well as for laying paving slabs, it is necessary to tamp the sand cushion in order to expel the excess air volume from it, squeeze the fine fractions of sand grains together as tightly as possible. After compaction is completed, the sand […]
Read more
How often do you need to change the oil in the vibrating plate? If the engine does not have oil filters, then you need to constantly change the oil, since dirt appears during operation. It is necessary to change the oil after the first twenty working hours, and then every time after 100 hours. Also, if the vibrating plate has […]
Read more
Fourth: how is the engine running in. Air-cooled engines “don’t like” idling. Start the engine, warm it up for 1-2 minutes. and run in at work. During the break-in, try to adhere to 50-75% of the load and take obligatory breaks in work after 20-25 minutes. After a break, when the engine has cooled down (15-20 minutes), you can continue […]
Read more
All about compaction of sand Before installing foundation structures or preparatory work under the screed, as well as for laying paving slabs, it is necessary to tamp the sand cushion in order to expel the excess air from it, squeeze the fine fractions of sand grains together as tightly as possible. After compaction is completed, the sand base becomes very […]
Read more
What is the oil in the vibratory plate reducer Oil for the vibratory plate. What oil to choose for a vibrating plate. Buy vibrating plate. For vibrating plates Moscow What oil is in the vibratory plate gearbox Oil to use for vibrating plates The vibratory plate has two mechanisms that require regular lubrication and oil control. It is a motor […]
Read more
Oriented particle boards are often used for exterior decoration of building facades and interior work. Their characteristic, rough structure does not always correspond to the style of the room or the desire of the owner of the house, so the surface is covered with paints and varnishes. Tips on how and how to paint OSB, properly prepare the material for […]
Read more