Trimmer for Patriot grass does not start a spark eat. Diagnosis of the graduation channel

Patriot trimmer does not start. Floods the candle on the gas troops what to do If on a wet candle it is still possible at least some appearance on the electrodes of the spark discharge, then on a “flooded” candle of spark discharge will be already impossible. We hear about “flooded” candles more often than about “flooded” engines. It is […]

Read more
blank

Which spark plugs are better ngk or Bosch

Many vehicle performance parameters depend on the right choice of spark plugs, particularly. driving speed and acceleration, fuel consumption. The manufacturer’s recommended type and size of plugs are listed in the car’s data sheet. But in addition to the basic characteristics of the part, you should pay attention to the materials of manufacture, the brand name and the number of […]

Read more
blank

No spark on trimmer plug

Checking the contactless distributor If the “six” is equipped with a contactless ignition system, then checking such elements as candles, a coil, and explosive wires is performed in the same way as with a contact one. The differences are in checking the switch and the Hall sensor installed instead of the contacts. Hall sensor diagnostics No spark The complete absence […]

Read more
blank

No Spark On The Stihl 180 Chainsaw

Identifying ignition faults It is very important for a lumberjack to make a correct diagnosis when his sawing tool starts to “mope”, or “falls into a coma.” This, I repeat once again, is extremely important, because the consequences of an incorrect diagnosis can lead to both unreasonable expenses, wasted time and even nervous breakdowns. The fact is that inexperienced lumberjacks, […]

Read more
blank

Trimmer Does Not Start Fills In A Candle Spark Is

complex reasons for lawn mowers failure If the step-by-step troubleshooting algorithm does not work, and your scythe still does not start or stalls, it is worth inspecting the carburetor and the engine itself. A clogged carburetor can be one of the reasons for erratic tool performance. There are three main problems here: Clogged ducts or nozzles. All this is cleaned […]

Read more
1 2