Trimmer Does Not Start Wet Candle

Due to soot on the electrodes of the spark plug: there are interruptions in the engine (the trimmer motor is triple), a drop in power occurs, and the engine can start poorly. Assistance to the project. It is planned to spend money on the purchase of a high-quality camera. Privat: 4149439390776312.

Pours a candle on a lawn mowing

It starts up well in the cold, but if you work a little and if you drown it, it starts up right away. The candle was constantly wet and began to throw the fuel mixture into the air filter. on a similar breakdown My second channel, almost every day.

Gas trimmer. Wet candle. Engine flooded.

A deposit on the electrode electrodes is formed due to improper adjustment of the trimmer carburetor, if there is a lot of oil in gasoline and when the air filter on the trimmer is dirty. How can “drown” lawn mowing engine, to be inattentive. Just one awkward movement.

A candle pours on a lawn mow

The main thing when installing the spark plug. First you need to wrap the candle several turns FROM HAND, and then take the key. If the candle went by hand easily, it means it is installed correctly and it can be wrapped with a tool (candle key with a screw). If the candle does not want to be twisted by hand, it is not worth tightening it with a key, since the candle did not go through the thread and the thread in the candle hole of the cylinder will inevitably be damaged and an expensive trimmer motor repair will be needed. A similar is my first channel :.

Why doesn’t the lawn mow / chainsaw start after long-term storage?

If the candle has not turned, then everything is fine, but with subsequent eversion of the candle, one must be especially careful. If the candle is cranked, you will have to install the futurka (repair sleeve). To do this, it is better to contact the workshop for repairing chainsaws and gas trimmers. Assistance to the project. It is planned to spend money on the purchase of a high-quality camera. Privat: 4149439390776312.

The Chinese lawn mowing will not start. This is interesting.

When I disconnect the power take-off, I start looking for everything that works fine! Again, I’m reconnecting, it barely starts and stalls, and maybe it doesn’t start at all! Spare parts for Chinese lawn mowing Chinese lawn mowing will not start. It is interesting.

# 128295; Why pours a candle in a chainsaw.

If the new candle also does not give out sparks. The problem is in the high-voltage wire or in the failure to connect to the candle. A brief instruction on replacing the membranes in the carburetor of a chainsaw.

Pours a candle chainsaw | Troubleshooting

Inspect everything on the trimmer for cracks, bends, abrasions, skews, tears (especially metal knives at the base of the teeth and at the holes and both protections). Reliably eliminate all malfunctions identified on the lawn mower. If you tighten the fasteners yourself, do not overtighten! Fills a chainsaw candle? We eliminate the cause of the malfunction. Help group VK.

Do not start a lawn mowing.

A cold trimmer engine with a closed carburetor air damper starts up almost normally, runs at high idle, unstable operation is observed when the engine is heated, after which the trimmer motor stalls. Do not start a lawn mowing.

Chainsaw does not start a wet candle

We lay the jammer wire deep in the groove, lay the candle wire in the groove on top of the jammer wire, put it in the clip and press it, we hook the gas cable in two places. Instagram my first channel: Free.

Fills the chainsaw candle

Poured gasoline with oil, oil was a little more than expected. And in the morning I wanted to start it, but as if holding a piston, it spins in jerks. And as I put a candle, the piston in the cylinder starts to slow down, walks tight and jerky. Dismantled the cylinder and removed the piston, from excess oil on the piston head and the cylinder was soot. Write the case here.

Doesn’t start on a cold trimmer. Eliminate the cause

There was a dispute, how to say it correctly: a high-voltage wire of a chainsaw (trimmer), or an armored wire of a chainsaw (trimmer). Which supplies current to a spark plug. The trimmer will not start to cold. Cause. Air leaks that prevent fuel from pumping. Into the camera.